Dimplex Electric Heater HAW1000N User Manual

Installation and Operating Instructions  
08/50511/0  
Issue 0  
Air Warmer: Model No. HAW1000N  
Dimensions  
(millimetres)  
Watts Electrical Supply Weight (kg)  
HAW1000N  
1000  
230-240V ~1PN  
14  
115  
207  
470  
Fig. 1  
THESE INSTRUCTIONS SHOULD BE READ CAREFULLYAND RETAINED FOR FUTURE REFERENCE  
Important Safety Advice  
Do not locate above or below a fixed socket outlet.  
The heater including the supporting legs can get very hot;  
therefore do not mount directly on any combustible  
material. Suitable fire resistant material is required  
between the heater and any combustible base or support.  
Warning: Before obtaining access to the terminals all supply  
circuits must be disconnected.  
The heater should be installed to allow a reasonable air  
flow around the heater.  
A prominent notice should be provided where the heater  
is sited ‘Keep Clear and Unobstructed’.  
x
Avoid exposure to water.  
The heaters are not suitable for general domestic use.  
The heater is suitable for a drying room provided that the  
heater has suitable ventilation.  
Fig. 2  
A mains lead which can operate at + 110°C must be used.  
Installation  
An all-pole isolating switch with a minimum separation of  
3mm in each pole must be fitted adjacent to the heater to  
facilitate local isolation.  
The installation should be carried out by a suitably qualified electrician/  
engineer in accordance with applicable standards.  
Remove all items from the packaging. The heater should be fixed using  
the fixing points provided - see Fig. 3. Ensure the heater is securely  
fastened.  
General  
This carton contains:  
1 HAW1000N heater  
1 Foldable guard  
Electrical connection  
WARNING – THISAPPLIANCE MUST BE EARTHED.  
Verify that the electrical supply cable is sufficient for the rated loading.  
Check that the incoming supply conforms to the rated supply.  
179  
The heater power circuit must be protected by a suitably rated over  
current device.  
449  
The incoming cables must be connected to the factory fitted heater  
terminals provided. Do not alter any factory fitted wiring.  
Fig. 3  
The Terminal Cover Casting can be removed to access the terminals, by  
removing the 2 screws fixing the cover - see Fig. 2.  
Remove the terminal cover and connect the mains cable, while making  
note of the path the connecting cable should take through the guard.  
WARNING: Ensure the power cable path does not come into contact  
with the heater element.  
Reattach the terminal cover to the heater and fasten the cable gland.  
The heater is supplied with an earth stud, located inside the terminal box,  
which must be connected to earth.  
Mount the guard over the heater. Ensure the guard is mounted centrally  
relative to the heater as shown in Fig. 4.  
After connection check the continuity of earth connections.  
The heater should not be connected until the instruction leaflet has been  
read fully.  
 

Compaq Computer Hardware 177620 006 User Manual
CyberData Switch 010845 User Manual
Delta Electronics Power Supply ISO 9001 User Manual
Dixon Lawn Mower 16134 0803 User Manual
Edimax Technology Digital Camera IC 1520DP User Manual
Electro Voice Portable Speaker DMC 1122X User Manual
Euro Pro Automobile Accessories CCK102 User Manual
Fellowes Paper Shredder OD1200 User Manual
Freecom Technologies Computer Drive Mobile Drive Secure User Manual
Gefen Switch EXT 3GSDI 441 User Manual