Coleman Camping Equipment 2000000436 User Manual

TM  
HOOLIGAN 2  
MODEL 2000000436  
6. Go to opposite end of the main pole and gradually apply  
pressure to the pole forming an arch. Insert the pin into the  
pole end. (Fig. 3 & 4)  
Before you begin  
Read all instructions before set up.  
• Select a level campsite clear of rocks, branches, and other hard  
or sharp objects, to install your tent.  
WARNING: Keep clear of overhead power lines.  
• Do not set up your tent under trees.  
• For best results in windy conditions, position peaked ridge of  
tent into the direction the wind is blowing.  
• Enlist the help of at least one other person to assist you when  
it is time to assemble the tent.  
Parts and Components  
Description  
Part Number  
Main Pole (1)  
Rainfly  
5010000251  
5010000266  
Fig. 4  
6. Drive in stakes at an angle through the two metal loops to  
help anchor the sides of the tent.  
To Set Up Tent  
To Attach Rainfly  
1. Unfold tent and spread out on a clean, level surface with the  
door facing perpendicular to the wind direction. Unzip door.  
2. Stretch out corners and sides of tent. Secure four corners  
with stakes driven in at an angle through the loops, at the  
end of the web straps, to better anchor the tent (Fig. 1 & 2).  
Note: Staking the corners will make it easier to raise and  
tear-down the tent.  
1. Drape rainfly over tent. Make sure vestibule and window on  
the rainfly are positioned over the tent door and the window  
on the tent. (Fig. 5)  
Rainfly  
Vestibule  
Window on  
back of  
Rainfly  
Sleeve  
Stake  
Stake  
Back of Tent  
Wind  
Direction  
Pin  
Window  
Pin  
Door  
Front of Tent  
Fig. 5  
2. Unzip door on rainfly and fold back flaps for better access  
to the hook & loop fasteners on the underside of the rainfly.  
(Fig. 6)  
Front of Tent  
Stake  
Fig. 1  
3. Wrap the hook & loop fasteners around the main pole  
to secure (Fig. 7). There are seven fasteners located on  
the rainfly.  
IMPORTANT:  
Plastic  
Loop  
Never drive stakes  
through plastic loops  
on the web straps.  
Fig. 2  
3. Assemble main pole by interlocking the black, shock-corded,  
sections.  
4. Insert main pole through sleeve in  
top of tent. (Fig. 1)  
5. Insert one end of black main pole  
into pin on metal loop located at  
either end of tent. (Fig. 3)  
Fig. 6  
IMPORTANT:  
Make certain all seven  
hook & loop fasteners  
are secured before moving  
Main  
Pole  
on to next assembly step.  
Fig. 7  
Metal Loop  
& Pin  
Fig. 3  
(continued on other side)  
 

Cooper Lighting Indoor Furnishings 124T5HO User Manual
Craftsman Tiller 91729604 User Manual
Crown Audio Speaker CTs 4200 User Manual
Dynasty Spas Hot Tub Deluxe System D 1000 User Manual
Edelbrock Automobile Parts Victor Series User Manual
Euro Pro Carpet Cleaner EP922HA User Manual
Fujitsu Laptop A531 User Manual
GE Monogram Double Oven ZET857DBSB User Manual
GE Network Card 1018959 User Manual
GE Washer Dryer WSM2700 User Manual